Features:
- 3/4" Yoke nut removal tool with 1/4" drive extension.
- This short socket tool allows to unscrew/screw the yokes from
regulators.
- A socket specially machined to fit between the nut and the yoke.
- An extension to allow a 1/4 male square key.
- The ideal tool to unscrew/screw a yoke, to the specific torque without
damaging the nut.
- Specifications:
Socket - 3/4 inch (19mm), Height 20mm, Square post hole 1/4 inch.
Drive Extension - Male and female square hole 1/4 inch, Full Length 50mm,
Maximum Diameter 12mm.
Description:
The Socket & Extension Set is specifically designed to remove, install, and
torque the yoke nut on most Apeks and IST R-8 series first stages. The extension
features a 1/4" square female drive to fit a 1/4" torque wrench or ratchet
handle. The extension shank has been reduced to allow it to pass through the
yoke screw hole. The bottom of the extension is machined to a square 1/4" male
drive. The 3/4" (19mm) socket features a 1/4" female drive and the exterior has
been shaped to capture the yoke nut completely. Both the extension and the
socket are hardened tool steel. The exterior is polished and nickel chrome
plated.
|