Features:
- Reduces jaw fatigue.
- Can repeat moldable.
- Different sizes available for specific model regulators.
Description:
Custom fit your regulator with this moldable mouthpiece. Simply heat in hot water, bite down, and you have a personalized mouthpiece. This piece is named Sea Cure, because its fit increases comfort and lowers jaw fatigue.
Three sizes depending on regulator:
Mode |
Fit Regulator |
SeaCure I |
Fits standard orifice regulators that have a conventional mouthpiece retention lip.
Apollo; Bridgestone; Coral; Dacor (new pacer model; not older pacer); Beuchat (VS-3,4&5); Cressi-sub; IDI; Parkway; Halcyon Rebreather; Pro Sub (Avalon); NDS; Nemrod; Scuba Pro; Seac; SAS; Sherwood (most early models/Brut/Magnum II/Oasis/Pre 1992 Blizzards); Tabata/Tusa 500 Series; Early Metal US Diver Models; and other standard size orifice regulators.
SeaCURE cannot be used on AERO model Dacor because of holes in body of mouthpiece orifice. |
SeaCure II |
Fits intermediate size air orifice regulators.
Apex; Atomic Titannum; Beuchat (VS-6&10); Chiaro; Mares newer model but not on Mares MR12II, III, IV or V); IST; Ocean Edge; Tekna; Oceanic; ProSub (larger size); Seaquest (not air source);Sherwood Maximus/Oasis 2/1992; Newer Blizzard; New Maximus (requires Professional Model only, the diver can grind one side of the internal core of the mouthpiece to maintain and venturi effect); Zeagle; and other intermediate size orifice regulators.
Poseidon / Sherwood Ultima - While SeaCURE is not designed to fit Poseidon or Sherwood Ultima, many divers are now using a Pro Model SeaCURE II with these regulators. It takes considerable extra effort and strength to mount SeaCURE II, but it will go on the plastic models, not on early metal units.
Never place the regulator end of SeaCURE into boiling water but only warm tap water on it for 2-3 seconds and a small amount of soap or spit on the orifice may also help ease it on. No other lubricant should be used.
DO NOT USE SPORT MODEL ON ANY POSEIDEN OR SHERWOOD ULTIMA - IT WILL SPLIT |
SeaCure III |
Fits US Diver Plastic
Regulators, new Seaquest, Genesis, & SeaMech
US Divers (Now AquaLung) regulators do not have the conventional
retention lip on the mouthpiece orifice common to all other
regulators and therefore no other SeaCURE model should be used on
Plastic US Diver regulators. |
Snorkels |
SeaCURE fits removable mouthpiece snorkels on the market. The SeaCURE model that fits is noted where known.
Amico (I); Cressi-sub (I); Dacor 3 models (I); Netex (I); Ocean Reef (I); Reef Buddy (I); Tusa 500 Series; IST; Parkway (II); Pic (II); Techisub (II); Ocean Master, Dry2000 (III); ProFlo SQC (III); Trident; US Diver (III). |
Not listed above? |
Simply measure the retention lip on the air orifice of the regulator. The results of a recent survey of regulators indicate that almost all fall into two general sizes with some in each group being slightly larger or smaller than the average.
Standard Lip - (1-1/4" x 3/4") takes SeaCURE I
Oversize Lip - (1-7/16" x 7/8") takes SeaCURE II |
|
Available Options: |